CI Panel enter password and change settings. (For mechanical engine.)
● Press and hold the menu button.
● Press the enter button and release while holding the menu button.
● Release menu button.
● Press enter button until the display shows "Controller setup"
● Press the up arrow until the screen shows " Enter Password"
● Press enter. (2 brackets show up with a 0 and 3 dashes.) The passcode is 4345.
● Press the up arrow to change the 0 to number 4.
● Press enter and change the second number to number 3 by using the up and down arrows again. Press enter again, do the same process with the last 2 digits. For Nr.4 and 5.
When the passcode is entered and all 4 digits turned in to stars. Press the up arrow then the menu button. This now starts the top level of the menu options.
We are looking to change settings in ‘Throttle Configuration’.
Settings:
● Scroll with the menu or the Enter button through the main menu and look for “Throttle configuration”
● Press the up and/or down arrows until “Act Coarse Tol” shows in the screen.
● Press enter and the brackets show in the screen.
● Change this number to 750.
● Press enter to save
● Press the up and/or down arrows until “Act Fine Adj Tol” shows in the screen.
● Press enter and the brackets show in the screen.
● Change this number to 25. (this means if the set value is within 25 of the actual value no actuator adjustments would be made. If more accuracy is required, an engine with an ECU would be a better fit.)
● Press enter to save
● Press the up and/or down arrows until “Act Fine Adj Dly” shows in the screen.
● Press enter and the brackets show in the screen.
● Change this number to 1000.
● Press enter to save
● Press the up and/or down arrows until “Act Pulse Off” shows in the screen.
● Press enter and the brackets show in the screen.
● Change this number to 960.
● Press enter to save
● Press the up and/or down arrows until “Act Pulse On” shows in the screen.
● Press enter and the brackets show in the screen.
● Change this number to 40.
● Press enter to save
● Press the up and/or down arrows until “Maintain Intrval” shows in the screen.
● Press enter and the brackets show in the screen.
● Change this number to 1.
● Press enter to save
● Press the up and/or down arrows until “Actuator Timeout” shows in the screen.
● Press enter and the brackets show in the screen.
● Change this number to 30.